![Buy imovie for windows](https://knopkazmeya.com/16.png)
![symantec firewall is not functioning correctly symantec firewall is not functioning correctly](https://higherlogicdownload.s3.amazonaws.com/BROADCOM/SymantecInlineImages/comment-11537111-files_FIREWALLERROR.jpg)
This indicates Tunnel Monitoring is working.Īfter successfully configuring Tunnel Monitoring, we can configure PBF rule monitoring under Policies > Policy Based Forwarding. Ideally we will see monitor: on and monitor status: up with respective monitor counters.
SYMANTEC FIREWALL IS NOT FUNCTIONING CORRECTLY HOW TO
To check Tunnel Monitoring status from CLI, see this article: How to Verify if IPSec Tunnel Monitoring is Working – Click OK to close all the dialog window, follow by CommitĪfter configuring commit, we should see a new tunnel WSS_Tunnel_2 interface status is UP (Green). – Click Proxy IDs tab > Add > WSS_Tunnel_2_proxy – Enter Destination IP 199.19.248.164 (this is Symantec datacenter IP) To be able to properly monitor the IPSec tunnel, we need to create a new IPSec tunnel with the following parameters: 90), we can only specify one Proxy ID for WSS Tunnel configuration. The existing IPSec tunnel WSS_Tunnel_1 is configured with Local Proxy ID 10.1.1.0/24. Palo Alto Networks firewall will send keep-alive using tunnel interface IP as the source address.
![symantec firewall is not functioning correctly symantec firewall is not functioning correctly](https://us.v-cdn.net/6032193/uploads/attachments/5919adef-2ff9-4421-96e5-a930010bd70c/37f3422b-2824-43e4-9949-aafd0100a10a_flexnet-log.jpg)
To monitor the IPSec tunnel, we need to enable Tunnel Monitor properties in IPSec Tunnel configuration under Network > IPSec Tunnels > tunnel_name. – Necessary security policy rule to allow HTTP traffic from trust zone to WSS_tunnel zoneĪssuming that both Palo Alto Networks firewall and Symantec WSS admin console are properly configured, we should see Tunnel Interface Status is UP (Green) under Network > IPSec Tunnels – PBF rule: WSS_OverIPsec_1 with Egress Interface tunnel.1 – IPSec tunnel: WSS_Tunnel_1 with Local Proxy ID 10.1.1.0/24 (to match Local site network above) – IKE gateway: WSS_IKE_Gateway_1 with Peer IP 199.19.248.164 (this is Symantec datacenter IP) – Tunnel interface: tunnel.1 with IP address 192.168.1.254/32 (firewall zone: WSS_tunnel) In this example, we are using the following parameters PBF rule is configured on Palo Alto Networks firewall to forward HTTP traffic to Symantec WSS tunnel.IPSec site-to-site VPN tunnel is configured on both Palo Alto Networks firewall and Symantec WSS Admin console.Using Trans-Proxy (Explicit Proxy over IPSec) design.– When IPSec tunnel is DOWN: PBF rule is disabled and HTTP traffic will be routed as per active routing table. – When IPSec tunnel is UP: PBF rule is enabled and HTTP traffic will be forwarded to Symantec WSS tunnel. – Monitor Policy Based Forwarding (PBF) rule: disable PBF rule if the monitored IP is unreachable – Monitor IPSec site-to-site VPN tunnel: set IPSec tunnel down if the monitored IP is unreachable Implement Symantec Web Security Services (WSS) in the cloud using firewall or VPN access method
![Buy imovie for windows](https://knopkazmeya.com/16.png)